A measuring tape is a device used to take the dimensions of an object or area. Tape measures come in diverse sizes and lengths ranging from smaller sizes of three feet or below to over one hundred feet in length. Regardless of the length of the tape measure being used you will often find them viagra pills in two types which are METRIC or IMPERIAL. The choice is yours to make for either one but probably the decision will be influenced by what you are measuring or by the country you live in.

Required Tool

Tape Measure

Required Material

Area or surface to be measured

Instructions

Usage Brand Cialis only requires you to pull out the tape and measure what you desire and then release for it to auto-retract or roll it back up physically based on which type you are using. If it is an imperial or metric tape measure there is no trouble reading the major numbers, however, there may be some difficulty reading the notches used for measurements between the numbered measurements. To differentiate between the two, imperial is measured in inches and feet while metric is measured in millimeters and centimeters.

Imperial tape measures are in sequence from one inch to the utmost length of the tape with notches between every number representing one-sixteenth of an inch. An easy method to read the notches is to think about the measurements out of sixteen at all times and then divide the number by two. Therefore counting the notches at the start of the tape measure we have zero, then one-sixteenth of an inch, then two-sixteenth and so on until you reach sixteen-sixteenth, where you would either continually divide by two until you have one remaining. Or divide the upper sixteen by the lower because they are multiples of two.

As such reading all the notches from zero to one inch you would have 1/16, 1/8, 3/16, 1/4, 5/16, 3/8, 7/16, 1/2, 9/16, 5/8, 11/16, 3/4, 13/16, 7/8, 15/16, and 1. Every 12 inches you go up on an imperial tape measure you will probably see the number of feet as well as the number of inches that you have measured. Since this has been typically regulated but may not be there in all brands of tape measures.

The metric tape measure is a bit simpler to read than the imperial tape measure due to the fact that the metric system is designed to have all numbers divisible by 10. A comparison would be that Viagra Professional the imperial uses inches and segments of an inch and feet; parts of an inch are divided into sixteen, and then twelve inches make one foot.

With metric 10 millimeters make one centimeter, and then 100 centimeters make a meter; all numbers are divisible by 10 and the notches on a metric tape measure between 0 and 10 instead of 16. This means you can quickly check for the measurement between zero and one centimeter by counting 0.1, 0.2, 0.3 etc until 0.9 and ultimately 1.0 centimeters. Any number thereafter would go on 1.1, 1.2 etc until 2.0 centimeters, and the trend would continue along the maximum length of the tape measure.

Tip

The imperial and metric standards are totally dissimilar, and while in some areas you may be able to convert between the two it is extremely unwise. individuals in the auto-mechanics field may say to you that you may be able to locate an imperial measurement which equals a metric measurement and vice-versa. But they will additionally say to you that the tools used may not fit exactly as a result of combining the two standards. For best results you must keep to one standard and if you are following a guide in a book or online use the prescribed measurements and standard.

Author Bio: Please visit these links for more information on: How To Read A Tape Measure and Read A Tape Measure.

Category: Science
Keywords: Tape measure, Standard measurement