A mouse trap car is a small vehicle built with a regular mouse trap and using the trap itself for energy. It is pretty easy to build a mouse trap car from scratch and the materials required are simple to obtain therefore here is a guide on building a mouse trap car of your own.

Required Tools

Pliers

Drill

Saw (optional)

Scissors

Required Materials

A mouse trap

4 eyehooks

6 balloons/rubber bands

Epoxy

2 bic pens/metal rods (axles)

2 tops from pop cans/2 washers

String

4 CDs/DVDs/plywood (wheels)

Instructions

Firstly drill 2 tiny holes into both sides of the mouse trap and screw the 4 eyehooks into them.

For wheels you can use 4 CDs/DVDs or you can cut 4 circles out of plywood with a saw. If you use CDs/DVDs, cut the top and bottom off 2 of the balloons using a pair of scissors and stretch the middle section over the rim of the CDs you will use for the back wheels to rubberize them for grip. You can still do this if you are using plywood however, this it is not a necessity.

If you use the pens for your axles, remove the top and bottom of the pen leaving just the vacant barrel. The eyehooks you have ought to fit narrowly over the pens or over the metal rods if you use them instead. It must not be so close however, that the axle cannot turn easily.

Create a hole in the middle of one section of the axles, big enough to run the string through. Run the string through the hole in the axle and out one end of the axle. Create cialis cheap a knot in the end of the thread you pulled out one end of the axle or tie it about something tiny and then pull it back inside the barrel of the axle so that the knot is inside the barrel (this is your back axle).

Then, put the front axle through the eyehooks on the front of the mousetrap (the side opposite to where the bait holder is) and use pliers to squeeze the pop can tops or washers onto the axle to stop the axle from moving around too much or sliding out sideways. See to it that the washers are not brushing the eyehooks or the wheels will not turn properly. Go ahead and additionally put in your back axle.

You may use epoxy to attach the wheels to the axles or you may wrap a balloon or some similar sort of rubber around the axle and then slowly push the wheels you are using on it. The balloons or rubber will function as a wedge and prevent the wheels from wobbling while the car is traveling.

Now for the movement of the car; fasten the string in the back axle to the center of the jaws of the mousetrap (the U-shaped piece that actually snaps on a mouse) and lift the jaws backward as if you are setting the trap. Hold the jaws tightly in that position and reverse the car until the excess string is completely wrapped around the back axle, set Brand Viagra the trap generic brands viagra online as you would to catch a mouse and your mouse trap care is set to go.

Set it down and use something to release the trap and look at it go!

Tips and Warnings

Make the eyehooks as level as possible so the axle is not crooked when you put it through the hooks.

Remember to put the rubberized wheels on the rear of the car, not on the front.

Be cautious to keep your hands away from the jaws when you are setting the trap because negligence can be quite excruciating.

Author Bio: Please visit these links for more information on : How to Build a Mouse Trap Car and Build a Mouse Trap Car.

Category: Home/Home Improvement
Keywords: Build a mouse trap car, DIY, Home accessories