A loft bed is basically a bunk bed with only a top bunk and an open space underneath. Because the bed is off the ground and takes advantage of the vertical area in a room, it provides you with extra usable floor space. Since you may put chests, drawers, desks, or anything else you wish below. Some individuals even use the space beneath a loft bed as a closet.

Particularly if you live in a tiny apartment where you need all the space you can obtain, or in a room shared by 2 or more children, a loft bed may be really useful and give a lot of additional space. Loft beds are not very expensive, you can see a loft bed for as little as $200 however, additional features like a desk or drawers will mean elevated prices. If you are a D-I-Y individual and you have some knowledge of what you are doing then you may construct a loft bed of your own as a weekend project. Here is what you will require.

Required Tools

Tape measure

Screw driver

Drill

Ratchet

Electric Kamagra Soft sander

Required Materials

Plywood piece

Screws

2 x 6s

4 x 4s

Lag bolts

2-inch thick wood slats

2×4 (optional)

Angle brackets

Instructions

It is always advised to begin with a plan; draw up a sketch of what your loft bed will look like and take out your tape measure to settle on the size your bed will be. To measure the size of your bed decide whether you want a twin, double or queen sized bed and use the size of the mattress to settle the size the bed frame will need to be. Build the frame an inch wider than the mattress to allow for bedding and then it’s time to head out and purchase the lumber you will use.

When you have all the lumber its time to get to work. Use the 2×6 pieces of board to build a box that ought to fit over the mattress you will be using. Drill holes through the ends of the boards and use a screwdriver to screw the box together. Screw angle brackets on the inside of each corner to strengthen them. Next place the sheet of plywood over the box to make the floor of the box. Attach generic viagra cheap the plywood to the frame with screws spaced 2-feet from each other.

Cut the 4x4s to equal the height you want your bed to be since they will be the posts of the bed. Place the posts in position and put the box on top of them (you will surely need a hand for this part). Drill holes from on top down through the box and into the top of the posts. Ihen use the ratchet and affix the box to the posts utilizing the lag bolts.

The bed itself is now complete however, you still require a ladder to get into it. Make a ladder using the 2-inch thick wood slats, with each slat around 10 inches apart. Maintain the grade of the ladder to 60 degrees and finally affix the ladder to the bed using a couple of screws.

Use the electric sander to smooth necessary places such as the ladder, and if you want you can add some stain and varnish as finishing touches.

Tips No prescription cialis and Warnings

If the bed is not as firm as you would desire it to be, use the piece of 2×4 to make a diagonal bracing across the rear of the bed (the side that will be against the wall) for further support.

It is recommended to use untreated wood for this project to minimize skin contact with any chemicals used for treatment.

Author Bio: Please visit these links for more information on : How to Build a Loft Bed and Build a Loft Bed.

Category: Home/Home Improvement
Keywords: Build a loft bed, sleep, DIY