A drain trap is located under the drain of sinks and toilets. The drain trap is important as it provides a seal to prevent the leak of harmful gases. Drains must be kept in good condition so they work properly, however, these traps can eventually become worn, damaged, and clogged. When this happens, it can require replacing the traps. When you know the steps involved with replacing a drain tap, it is not that difficult to do. Below are the steps involved with replacing a drain trap:

1. To replace it, you will need the following tools: bucket, wrench, screwdriver, new replacement trap, and plumber’s joint compound or tape. When you purchase a drain trap, it will include a number of components. Drain trap kits can be used for almost all installation projects and are available at plumbing supply stores and department stores. The pieces are fragile so it is important to handle them with care. The drain trap assembly will include: drain trap, tail piece, drain extension, and other smaller components.

2. Before you start the repair, turn off the home water supply or the water that travels to the pipe where you will be replacing the drain trap.

3. Use a wrench to carefully remove the trap. The water will flow out into the buck that you have positioned underneath. Keep the trap upright as you remove it. Remove the tailpiece and unscrew the trap from the drainpipe. Make sure you wait until the water has flowed out. If the trap has a cleanout plug on bottom of curved section, use the wrench to remove it. If not, unscrew the slip nuts and move them to the side.

4. Once you have completely removed the old trap, you can begin to insert the new one. There should be directions that come with the newly purchased trap. Make sure the slip nuts, washers, and compressions are properly aligned. Make sure all connections are tight and secure. You have the option of using plumber’s joint tape or compound to help with securing connections. Applying the plumber’s joint tape around the pipe fittings will help prevent leaks.

5. Once you have secured all connections, washers, joints, and other fittings, you should turn the water back on and run it to make sure there are no leaks and to fill the trap with water so that there is an effective barrier against sewage gases.

It is essential for your health and safety to make sure drain traps are kept in good working order so there are no sewage gas leaks. Leakage and seepage of sewer lines are not always detected right away, so it is important to check your traps to make sure they are still in proper working order. As well, it is important to maintain your water and sewer lines to prevent clogs. Preventative measures such as using a bacterial enzyme will help keep the pipes clean and odour free. Whatever the reason, a damaged and malfunctioning drain trap should be immediately repaired.

Author Bio: Searching online for a local plumber to fix your drains Aurora and plumbing problems? Then be sure to contact the drains professionals at Mr.Rooter, offering full drains Thornhill services 24 hours a day!

Category: Home Management
Keywords: plumbing,house,home,household,renovation,repair,family,business,services,contractor,toilet,lifestyle