To construct a wooden bunk bed, you have to get the necessary materials and also equipment, attach all of the two by 6 boards to the posts, drill slots in the posts as well as the side boards, connect the sideboards to the posts, drill holes on the headboard and footboard and connect them to the posts, cut the one half inch plywood and connect it, and calculate the space between the lower and upper bunk.

Bunk beds are a helpful option to enhance small floor space. This type of bed could also allow 2 young children to have privacy even if they\’re staying in a similar room or space. In case you make your own cheap bunk beds furniture you could save on both money and space. Follow these ways:

Secure the important components as well as tools

To construct a bunk bed, you will need to have four pieces of four by 4 posts that are 6 feet long, 2 pieces of two by 6 boards that are about 7.25 ft long, two pieaces of two by 6 plyboards which are approximately four ft long, two one half inch plywood pieces that measure about thirty-nine by seventy-five inches, washers, nuts, lag blots, and buildin tools. Make sure your lumber items match the above specifications. If not, you can slice them to the ideal length.

Put all of the 2 by 6 plyboards to the posts

Indicate the inner sides of each four by four posts to indicate where the footboard, sideboards, and headboard of the lower side of bunk should be. The lower edge of the two by six side boards must be not less than 1 ft . away from the floor. The footboard and headboard must be lied on the sideboards. Ensure the 2 by 4 items are attached to the inner areas of your 4 by 4 posts.

Drill slots on the side boards and the post

On the outer part of the 4 by 4 posts, get ready to drill the slots which will be used to attach the side boards. Make reference to the marks you created for precision and do not forget to consider the needed dimensions. You should also indicate the holes you\’ve drilled so that they form a diagonal line that runs throughout the post. Lat out the items that you will be drilling and also scrutinize the markings you have produced. When you have determined that the marks as well as sizes are right, you can start drilling the openings through the posts and sideboards.

Attach the sideboards to the posts

Once you\’ve drilled the posts and sideboards, you may now install them together. Make use of the lag bolts to fasten the sideboards to the posts.

Drill openings on the footboard and headboard and affix them to the posts

You\’ll now have to drill holes through the headboard and footboard. After you\’ve drilled the slots, you can connect them to the posts with the lag bolts.

Cut the 1/2 inch plyboard and connect it

Chop the 1/2 inch plywood so that it will fit onto the top of the sideboards. Once the plywood is the correct dimension, you can connect it to the sideboards by using screws.

Estimate the space between the upper and lower bunk

Allocate adequate distance between the lower and upper bunks so the occupant on the lower bunk can sit up. Once you\’ve completed the lower bunk, repeat all the previous procedures to make the upper bunk.

This project will result in a simple bunk bed that can support twin size mattresses.

Author Bio: Written by Douglas R. Williams. If you are looking for a wide selection of cheap bunk beds furniture that are ready-made, check out http://www.bunkbedsnow.com/cheap-bunk-beds-furniture.html

Category: Home Management
Keywords: cheap bunk beds furniture,cheap bunkbeds furniture,cheap bunk bed furniture