Vinyl siding is no doubt one of the most common exterior building materials today. In fact, more than 2 billion sq. ft of vinyl sidings are produced in the United States every year. Thousands of homeowners prefer vinyl sidings to other materials because it is affordable, practical, durable, flexible, and easy to maintain. Also, vinyl sidings are easy to install. You just need to have the right equipment and patience. Vinyl siding installation will be completed in matter of hours even if you are not that skilled.

As mentioned above, vinyl siding installation requires the right equipment. Do not worry about spending a lot of money because all you need are basic tools such as hammer, tape measure, level, chalk line, utility knife, framing square, tin snips, caulk and gun, cutting or sawing table, and circular saw with a fine blade. You can also use a drill, ladder, zip unlock tool, and other staging equipment. Specialty tools such as a nailslot and snaplock punch are also needed.

To begin the vinyl siding installation, you have to prepare the surface that will have the siding applied. It has to be clean, so wash the walls thoroughly to remove dirt and debris. It also has to be solid and smooth. Make sure that energy leaks are sealed and cracks around doors and windows are caulked. If you want to improve energy efficiency, you may install foil-based foam sheaths. This is especially recommended if you are installing a vinyl siding over an existing wood or brick surface. If you are installing a vinyl siding on a new house, however, make sure to install foil-based foam sheaths and a barrier meant to filter oil and water.

Then, the starter strips have to be installed at the base of your exterior walls so your lowest siding panels will be properly sealed. You should start at the bottom and finish at the top. Remember that your vinyl siding pieces interlock with one another; and making a mistake will mess up the whole vinyl siding installation process. Moreover, the corner caps must be installed on every corner where the walls of your house meet. These caps act as vertical channels that cover up the joints of the siding panels and result in a good finish. Installing such corner caps can be a bit difficult, though. So, you have to be very careful.

When it comes to installing trim strips or J strips, be sure to take the correct measurements. These strips will be installed around the windows and doors of your house. You can fix them up with nails. Once you wall is ready, you will need to install the siding panels. You have to start at the bottom of the wall and work your way to the top. Place the first panel and lock one side into the starter strip. Then, secure the other side with roofing nails and lay the next panel above it so they will overlap each other. Continue installing the panels until the walls of your house are covered. Follow the instructions provided by the manufacturer to make vinyl siding installation accurate, safe, and fast.

Author Bio: Do you want to know more about vinyl siding ? Visit our website at vinylsidingworld.com to get expert advice, reviews and great information, including amazing vinyl siding colors .

Category: Home Management
Keywords: vinyl siding,vinyl siding installation,siding installation,siding panels,vinyl sidings,prefer vinyl