If water is coming out too hot or too cold, correct plumbing tips assist individuals in solving these problems. By following good advice they can save money on otherwise expensive plumbing repairs done by professionals. Fixable problems include clogged drains, frozen pipes, and other plumbing problems.

When there is no hot water check for unlit pilot lights or one that may occasionally burn out or flicker. If unlit carefully relight the pilot light fire. If it burns out make sure gas controls are turned on the entire way. Also make sure the thermocouple is securely connected to the gas control unit and is close to the pilot flame.

If hot water exists but not in sufficient amounts, check the thermostat. See what happens after turning it up higher. Also examine pipes for openly exposed areas and try to add insulation to them. Sediment may have settled in the tank and reduced the availability of hot water in this way. Upon inspection, if sediment is seen, turn off the gas and drain the tank. Also look for leaky faucets that may need repair or replacement.

If water is too hot it is also necessary to check the thermostat. Try to lower its setting and see if the problem is resolved. An additional possibility is that the exhaust vent is blocked. If this is the case, remove the blockage.

In cold weather when faucets are turned on and no water comes out the pipes might be frozen. This can be prevented or quickly fixed soon after freezing occurs to prevent serious damage. To prevent the initial freezing keep steady trickles of water coming from every faucet. Heat any exposed pipes with heaters or lamps. Pipes that are not insulated must be wrapped with insulation such as heating wires, tape, or foam.

If pipes are already frozen, shut the water off at the main valve. Then open the faucet that is closet to the frozen pipe. This allows the water to drain as the ice melts. In case of leaks, make the surrounding areas waterproof with coverings or containers. Slowly warm up frozen pipes from the faucet down to the direction of more frozen regions. This is done with heat lamps, heating pads, hair dryers, or propane torches.

Unclogging a drain can be done after examining stoppers in a sink or tub. Look to make sure it is open all of the way and not clogged with tangled hair or debris. If these are not problems the drainpipe is likely clogged. This can be fixed usually using a plunger or any chemical drain cleaner solution.

Not enough, or too hot water can generally be fixed with inspection and minimal correction. Malfunctioning exhaust vents, faucets, thermostats, or pilot lights are all easily corrected. Freezing pipes are preventable or can be slowly defrosted to protect against extensive damage. This is done with heating equipment like hair dryers or wires. A clogged drain can be fixed by clearing debris or adding a chemical declogger purchased from a store. All of these plumbing tips save money.

Author Bio: Mister plumber is a leading plumbing company in Toronto and the GTA. Offering plumbing services and repairs for all of your Mississauga plumber needs.

Category: Home Management
Keywords: plumbing repair Toronto, plumbing Toronto, plumbing service Toronto