Concrete polishing tools are a necessity when performing a true polish job on the surface of a floor. The tools are used during two different processes, each of which has its advantages and disadvantages. The dry process is nice because it causes less mess than its counterpart; however, it will go through abrasive discs quicker.

When using the wet method, the process generates more of a mess because it is mixed with the dirt and dust that is being removed from the area. In order to clean up this mess additional equipment such as mops and brooms are used to remove the waste water. The upside to using this method is that the abrasive discs will last longer because the water acts as a lubricant that keeps them cooled down.

Because the polisher is so important, it is the main focal point when purchasing or renting equipment to do the jobs. The main component that should be checked when looking at these models is if it has a planetary drive. A planetary drive is a single disc in the center known as a primary disc and three to four additional discs around it that house the abrasives.

Another thing to check is the weight of the polisher because the heavier the machine the better job it will do. Also if the job is a dry method job, the machine will need an attached vacuum bag that will capture the dust as it is created. Edging and hand held models can be used to reach hard to reach areas such as corners and steps.

Abrasives are also very important and they are purchased in pairs, one is a coarse model and the other is a find model. The coarse model is used for breaking up old wax and particles that have adhered to the floor and also making the surface rough so it will accept the coatings. The fine model is used to hone the area and perform the final steps during the polish process.

After the coarse abrasives have removed the top layer of gunk, a filler is applied that will repair any cracks or damage to the surface. After the filler is done setting up, a hardening coat is applied and helps protect it against water and stain damage. The hardener also works to improve the finished polish because if the surface is harder it will polish easier.

When the polish has been completed, a good idea is to spray a stain guard over the area that will provide additional protection. The guard is ideal for areas like auto shops where oil is likely to get spilled on the surface along with other chemicals. Applying this mixture is generally done with a sprayer or a wax application device.

Using the proper concrete polishing tools will ensure the job is done right the first time and can create a surface to be proud of. Taking time to research the available models will also assist in purchasing a quality piece of equipment. In the event that the equipment is too costly for purchase, rental equipment is available from local home improvement stores.

Author Bio: Nufinish’s line of concrete grinding tools and concrete polishing tools reduce the amount of steps required to produce stunning polished concrete, saving you time and money.

Category: Home Management
Keywords: home,society,family,improvement,motivation,renovation,business,investment,economy,finance