Most new windows come with a screen already attached; However you may face the task of replacing damaged screens or installing screens in older windows.

Fortunately, this task is simple and takes no prior experience. There are only a few things you need to find out before you can install your new screen. First, the measurements of the screen and secondly, the material used to make your screen frame. Pay close attention to getting exact measurements because even the slightest wrong measurement will lead to purchasing the wrong screen.

A benefit of replacing your own insect screen is cost. To have some install a new screen prices run around 30 dollars but if you install the screen yourself the price will run you around seven. After you have purchased the appropriate mesh for your replacement screen you will need to follow the detailed instructions listed bellow to install your new screen properly.

First, remove the screen frame from the window. Some models will have a small lever you can push and it will pop right out. Others you may have to use a screwdriver to remove the tabs holding the frame in place.

Second, place the frame on a flat working surface. With a flat-head screwdriver in between the groove of the frame, lift and twist slightly so that the frame separates. Continue along the frame until the frame is in two parts.

Third, remove the old screen and clean the grooves so that there is no left over gunk from the previous screen. This will help with a better install of the new screen.

Fourth, measure the length and width of the remaining frame. Cut a similar size piece of screen mesh from either fiber glass or aluminum insect screen. For aluminum screens use wire snips and for fiber glass use scissors to cut the mesh. Set the mesh into place over the solid frame.

Fifth, replace the other pieces of the frame to the top. Allowing the new insect screen to be clamped tightly in between the grooves of the frame. Some frames may require a special installation tool to fully clamp the frame.

sixth, trim the excess mesh. Use either scissors or a utility knife. Cut towards the outside of the frame in order to prevent cutting the new insect screen.

Finally, replace the window screen to the appropriate window. Either clamp the screen into the window or attach the tabs with a screwdriver.

If you follow these simple instructions you will have learned the skill of replacing insect screens, you will have replaced your damaged or old windows screens, and you will have saved yourself quite a few bucks. Take the time to replace your insect screens yourself. The benefits out way the little time and energy spent to do it yourself. Never have to pay another person to come to your home and replace your insect screens again. Good luck on your way to learning how to replace your damaged screens or older windows screens!

Author Bio: Trevor Richards writes for Better Blinds, UK retailers of fly screens

Category: Advice
Keywords: insect screens, fly screens, insects, pest control, ants, house, home, window blinds