Heat has many applications in industry and in homes. It is required for smelting metal ores and in chemical reactions which require a high temperature in order to take place. Heating and furnace is also important in simple tasks like cooking and in keeping houses warm during very cold weather like winter.

This heat is produced in furnaces which may vary in size according to their use. Furnaces, like all equipment break down and once in a while one may be forced to maintain and repair them even tough they are quite reliable. It is important to fix the furnaces quickly. You can resolve a variety of furnace problems yourself with proper guidance.

If the furnace is gas operated, then a gas leak will most likely occur. Deal with this immediately. It is easy to detect a gas leak as it has a distinct odor. If you smell gas, do not light any matches or turn on or off switches. Evacuate the building immediately if the smell is strong and leave doors and windows open.

Pilot lights are another common problem, especially in older versions of gas and fuel operated furnaces. The pilot light may sometimes fail to stay lit as a result of a possible number of reasons. The orifice may be sealed, but this is easily fixed by use of a thin wire to clear away debris which has accumulated in the pilot orifice. It may also be as a result of a malfunctioning thermocouple.

Another problem could be the furnace does not heat enough or it does not heat at all. If the heater is not providing enough heat, make sure nothing is blocking the air flow out of the system. Raise the temperature of the room by a few degrees and wait a while incase the thermostat is not set properly. Check if the heating registers in the room are open and also check the filter is dirty. If it is, then replace it.

If there is not any heating at all, usually it is because of a malfunctioning thermostat, a tripped circuit breaker or a blown fuse. If this happens, check whether the thermostat is set to heat in case it is a combined heating and cooling system. Check the main electrical panel and secondary panels to ensure circuit breakers and fuses are intact. Reset the circuit breaker by switching it off then on again and replace any blown fuses.

To make sure that the flame always comes on, several factors should be observed. For example one must make sure that the valve that brings the gas to the combustion chamber is on, if not, then turn it on. The pilot light must also be present so that the flame can come up.

Thermostat malfunction, overheating of the system due to clogged or malfunctioning blowers and filters may result in the furnace cycling on or off to often. Clean or replace the filters and if that does not solve the problem, call a repair man.

The advantages to doing the heating and furnace repairs are that you save a lot of money and you may also get to heat up your home much faster than you would if you called and waited for a repair person.

Offering a custom range of home repair services in Heating, Toronto furnace repair, and Toronto heating. We are Durham\’s most trust home contractor service.

Offering a custom range of home repair services in heating, furnace, and air conditioning. We are Durham\’s most trust home contractor service.
http://www.brownshomeheating.com/

Author Bio: Offering a custom range of home repair services in Heating, Toronto furnace repair, and Toronto heating. We are Durham\’s most trust home contractor service.

Category: Home Management
Keywords: heating, air conditioning, cooling, furnace, repair, home, family, home improvement