Tiles are manufactured pieces of hard materials generally used for floors, roofs, and walls at our houses. The common materials used for its production are stone and ceramic. Today, these objects are not just used as reinforcements or additional layers for infrastructures but are good contributors of aesthetical beauty. With the proper choice of tiles, the physical appearance of the floors, walls and ceilings can be enhanced. But what will happen when tiles are worn out? What are the proper methods to be used in its removal? This article will provide simple steps in residential tile removal.

Before anything else, it is vital to know the materials to be used in the removal of these tiles. The common materials to be used in residential tile removal are: wide-bladed cold chisel, club hammer, scraper, goggles, dust mask, riggers gloves, rubble sacks, old blankets and plaster filler. All of the aforementioned items are essential to conveniently remove tiles.

The first thing to do is make sure that all nearby surfaces are cleaned and protected. Valuable objects, appliances, and worktops must be covered with old blankets or sheets as the tile chips can scratch their surfaces. Once the expensive objects and areas have been protected, the tiles are ready to be removed.

Aiming at the bottom part of the first tile, the cold chisel should be pounded using a club hammer. During this process, the cold chisel should lever the tile upward. It is important to have the proper sequence during the removal. The ideal starting point is along a grout line. All the other tiles across the wall or floor will be removed using the same process. The collected pieces of tiles will then be stored inside the rubble sacks. It is important to take extra careful in this process as the small pieces of tiles can also scratch the floor.

After all the tiles have been removed, any remaining grout or adhesive should be chipped off using a scraper or cold chisel. In the case of loose plasters, it should be chipped off and be filled with plaster filler. Two layers may be used in order to have the optimal thickness. For stud walls, the plasterboard may be scratched in the removal of tiles. Removing the whole plasterboard and replacing it with a new one may be easier before redecoration.

After the old grout and adhesives have been scraped off, new tiles may be applied. For tiles that have minor cracks or chipped off pieces, a single tile replacement can be applied. Three or four holes can be drilled closely to one another in a vertical line. A cold chisel and hammer can then be used to hammer the tile and break it to pieces. The loose pieces are then levered away from the floor or wall. Loose grouts on edges can be cleaned off using a chisel or craft knife. For plasters that came away in the removal of tile, a plaster filler may be applied to the hole. Tile adhesives are then applied at the back of tiles. The tile is then pressed onto the surface and checked with other tiles for uniformity. The excess will then be cleaned using a sponge or squeegee.

Residential tile removal may not be difficult if one will carefully apply the steps provided above. Furthermore, there are companies that will provide useful tips for removal of tiles. People who seek help in tile removal may look into 3-D Construction – (St. Pete, Fl 33704). For sure, inquiries and problems in tile removal could be attended to.

Are you looking for more information regarding residential tile removal? Visit http://www.3dconstructionenterprises.com/ for more information!

Are you looking for more information regarding residential tile removal? Visit http://www.3dconstructionenterprises.com/ for more information!

Author Bio: Are you looking for more information regarding residential tile removal? Visit http://www.3dconstructionenterprises.com/ for more information!

Category: Home Management
Keywords: residential tile removal