Installing LED tube lights is a great way to save money on electricity by installing LED tube lights and also get hazardous fluorescent light bulbs out of your home or office. But, most LED tube lights on the market presently cannot just be directly installed in an existing fluorescent fixture.

It is a great way to save money on electricity by installing LED tube lights and also get hazardous fluorescent light bulbs out of your home or office. But, most LED tube lights on the market presently cannot just be directly installed in an existing fluorescent fixture. You will have to make some simple modifications to the fixture to properly install the light bulbs. The good news is that installing LED tube lights in an existing fluorescent fixture is quite simple. Additionally, you should be able to purchase fixtures designed for LED tube lights in the near future, and in fact they should be cheaper than the equivalent fluorescent light fixtures.

Fluorescent fixtures are in fact designed to support specific types and size of fluorescent light tubes. A fluorescent tube is incorporated into a fluorescent lighting system that consists of two or three main components, which is the fluorescent lamps, the ballasts and the starter systems. Additionally, the system for a tube lamp includes a lamp holder and a switch. Depending on the particular fluorescent lighting system, the starter may be a replaceable component, a starter may not be required, or the starter function may be integrated into the ballast. The starting function may also rely on the physical design of the fixture. To retrofit a fluorescent fixture to support a LED tube light, the ballast must be disconnected.

You have to ensure that the LED replacement tube lights are the correct size for the fixture. You also need to remember that when servicing a fluorescent fixture or lamp, the electrical power to the entire fixture should be disconnected. This is not always practical in situations where a huge number of fixtures are controlled from the same power control (such as in open office areas). In such cases, insulating gloves and a non-metallic ladder should be used if the fixtures must be serviced when the power is present.

You will need a few simple tools, including a wire cutter and wire stripper, a pair of pliers, a screwdriver, and a few wire nuts for reconnecting the wires once you have removed the ballast.

Once the traditional light bulbs are removed from the lamp holders and the electricity to the fixture is turned off, you will have to remove the reflector which is located behind the light bulbs and provides a housing for the wiring and ballast which lie behind it. Typically, it is quite simple to remove the reflector or cover, however if it is not clear how to do this, you should consult the documentation from the fixture manufacturer.

Nowadays, high quality LED lighting bulbs have surpassed the normal conventional lights when it comes to energy consumption efficiency. The reason is that LED consume lesser energy makes them a great lighting alternative for use in companies and for residential houses as this would assist in reducing the electricity bill payable for putting lights on by a great portion. LED lighting in fact use only about 30 percent of energy which fluorescent light bulbs use to produce a particular level of brightness. They also save you a large sum of money as they last much longer than fluorescent light tubes.

For more information on Ai LED tube lights, pls visit Ai LED tube lighting.

For more information on Ai LED tube lights, pls go to http://www.ai-m.net/LED%20Light.pdf and http://www.ai-ledlight.com/

Author Bio: For more information on Ai LED tube lights, pls visit Ai LED tube lighting.

Category: Home Management
Keywords: Ai LED tube lights, Ai LED tube lighting, LED tube lights