When it comes to energy-efficient lighting electricians and light designers know that LED, which stands for light-emitting diode, are on top of the hierarchy. Similar to fluorescents and other bulbs, LED tubes come in different wattages. However, for standard bright lighting, you may opt for high output T8 22 watt tubes.

The installation is quite easy. But, it\’s important that the ballast of the fixture you use is configured specifically for LED. Remember: you can never place LED light tubes in fluorescent fixtures, and vice versa. For this reason, you may need to remove the ballast to adjust the wirings. To do this, follow this step-by-step procedure.

Firstly, make sure that the power is turned off to prevent electric shock accidents during installation. After this, you are required to bypass the electronic ballast. You do these by connecting all the tubes stored wires to neutral and the other one to line voltage. Although you are required to hook up the right set of wires to the right place, you can put the tubes either way once you have completed this step.

Secondly, now that you have bypassed the electronic ballast by following the previous step, you now proceed to checking it. By now you have got your line voltage neutral and ground coming through your fixture. The ground is hooked up to a specific chopper/nut. You can take it from one of the tubes next to the chopper/nut and hook it to all the wires that come from one end of the fixtures. These will be assigned for the neutral. Trace the line coming into the node, and all the line fixtures coming out of its other side will serve as your line voltage for hot. With a LED light tube, as long as you have properly assigned the wires properly, you can put the tubes in either way.

Thirdly, before you place the fixture back together, you need to check first if all the wiring connections are working right. To do this place one LED tube and turn the power back on. If it lights up, then it is working. Thereafter, turn the power off again before you put the cover plate back in place.

Fourthly, the last step prior to placing all the LED T8 tubes is to put a sticker or label on the plate. It indicates that the fixture has been adjusted to specifically accommodate LED tubes. This allows electricians who will replace the tubes in the future to know which fixtures can be used for which particular tubes. Once a fixture has been adjusted for LED, it can no longer be used for fluorescent or other kinds of tubes. See to it that the label is on the center of the plate or any other place where it can easily be spotted.

Fifthly, now place all the tubes and other labels in the light box. The whole process will take up about a few minutes. Once you have completed this step, you can put the cover back on. Test all your lamps by turning on the switch.

For more information on Ai LED Light Tubes, pls visit LED Light Tubes.

For more information on Ai LED light tubes, pls visit http://www.ai-ledlight.com/ and http://www.ai-m.net/LED%20Light.pdf

Author Bio: For more information on Ai LED Light Tubes, pls visit LED Light Tubes.

Category: Home Management
Keywords: Ai LED Light Tubes, LED Light Tubes