It takes patience, diligence and some carpentry skills to construct a good staircase.

Technically, it’s not that difficult to build a staircase. The most important thing about learning how to build stairs is to take accurate prescription cialis online measurements. Check your calculations so you don’t discover any mistakes AFTER you start construction and waste time and money correcting them.

A staircase comprises the stringers, the risers and the treads. The stringers form the framework of the staircase. The risers are the vertical section of each step attached to the front of the stringers. Some staircases have no risers, but they can protect the stringers from weather exposure and prevent accidents. The treads, like the name suggests, are the horizontal portion the stairs and are the final pieces in the installation of a staircase.

To build a staircase for your deck, you have to measure the total rise, or vertical height from the first finished floor to the second finished floor. You also have to calculate the total run needed, which is the horizontal distance between the landing and the edge of the upper level.

To obtain the number of risers/stairs required, divide the total rise by 7.5. A total rise of 64 inches divided by 7.5 is 9.14. Round this up to the nearest number and you’ll find that you need 9 risers. You need one less tread than a riser because the last step is either on the ground or same level as the upper floor.

For the height of each Kamagra Gold riser, divide the total rise by the number of risers. A total rise of 64 inches spanned by 9 steps requires risers 7.11 inches high. The total run is derived by multiplying the number of treads (8) by the width of each tread, e.g. 10 inches. Therefore, the total run is 80 inches.

Mark your measurements on 2′ x 12′ stringers with a framing square. Mark the rise and run (7.11″ and 10″, respectively) beginning from the top of the stringer. The notches cut out with a circular saw from the first stringer can be used as a pattern for subsequent stringers.

The stringers are attached to the deck by toe-nailing or direct attachment to the framing of the deck itself with joist-hangers. Install the treads starting at the bottom. Screws or 3 inch nails are used for this job. Good-quality wood should be used for the treads and finished properly to ensure longevity.

Author Bio: Please visit these links for more information on How To Build Stairs and this link for information on How To Build A Staircase

Category: Home/Home Improvement
Keywords: How to Build Stairs, Staircase, DIY, Home Improvement