Installing a Sod Lawn

If you are interested in a quicker and easier way to get a lush, green lawn, installing Sod in lieu of old fashioned seeding could be the alternative you’ve been looking for. Seeding a lawn can sometimes take an entire season to mature. Planting sod is a relatively easy task to complete, and you can lay sod anytime from early spring to late fall as long as it is adequately and regularly watered. The greatest disadvantage to sod is its higher cost (grass seed typically costs much less), however the rapid results can be well worth the initial investment.

In this post, we will outline the steps needed to install sod on your lawn.

* Lay the first row in against a straight line such as walkways or fencing
* Tightly mash the ends of each sod roll together
* Lay each row in a staggered pattern
* Cut sod to custom-fit irregularly shaped areas
* Tamp seams with the back of a rake or shovel

Soil Preparation

Soil preparation for sod is very similar to seeding, but the main difference is the finished grade of the soil. Because sod comes with its own soil attached, the grade should be approximately 1.5″ to 2″ below surrounding hard surfaces. You should apply a starter fertilizer high in phosphorus or lime, depending on your base soil’s pH level, to the soil surface and lightly rake it in to the soil. After soil preparation, you are ready to start planting the sod.

Laying the Sod

Sod should be planted as soon as possible after it is harvested. If you are unable to lay it immediately after purchasing, store it in a shaded area to prevent killing it. The first row should be placed along a straight edge such as a walkway, fencing or driveway. Place the next row at the end of the first mashing the ends together, avoiding any gaps between each row. Each adjacent row should be laid in a staggered brickwork type pattern. When sodding slopes, you should lay the sod perpendicular to the slope (vertically along the rise) and use stakes to temporarily hold it in place.

You should use a board to stand on previous rows to spread your weight out as you work and prevent gouging the sod. Not all lawns are perfectly rectangular like sod, so you may need to trim the sod along curved portions. For a guide you can use sections of string to cut straight lines and a garden hose for curves. It is easiest to cut the sod with a heavy knife, small hatchet or a half-moon edger.

When all the sod is firmly in place, tamp down all the sod rows with the back of a rake or shovel to remove any air spaces between the sod and the soil, as air pockets cause the sod to dry out and die because it wont be able to draw water from the soil underneath. The last task to perform is to water the newly laid sod sections. You should aim for wetting the upper 6 to 8 inches of soil. This will help the roots search for moisture and grow deep into the soil. Continue watering deeply, but space each application to avoid a constant saturation of the soil. Over-watering soil can delay the growth of roots.

Summary

You should avoid walking on the lawn until the sod has rooted well to the soil beneath it. This often takes as long as two to three weeks. You can check by very gently lifting up on the grass. If the sod layer doesn’t raise up, then it is rooting and most likely in good health. One month or so after sodding you can begin to treat it like a mature lawn. You should apply a standard lawn fertilizer and begin a regular watering schedule of around 1″ per week.

Author Bio: Kostas Menegakas is the owner and manager of Landscapes R Us, a local and regional landscape design company based in High Point, NC.

Category: Gardening
Keywords: sod lawn, laying sod, lawn turf, watering sod, installing sod, sod installation

Leave a Reply