If you would like to create your personal travel file holder, prepare the things you need, slice the fabric into 4 pieces, fold and topstitch pieces B and C, stack the pieces together, start sewing, place the hair flexible, place the 2nd piece A and sensed, and add the final touches.

If you take a trip a lot then you learn how bothersome it may be to keep your passport and travel documents in order. You may use job ticket holders to keep your travel tools safe or you could produce your personal travel file holder. Below are the guidelines for this particular craft:

Prepare the things you need

To create your personal travel record holder, you need a non-stretchable fabric that measures 13\” by 44 inches, a piece of 10.5 inches by 11 inches felt in different color, one button which has a width of 5/8\” to one inch, hair elastic and some pins.

Slice the cloth fabric into 4 pieces

Begin the task by slicing the cloth fabric into four parts of the following dimensions:

* Piece A must measure 10.5 inches by 11 inches. Cut 2 pieces of this dimension.

* Piece B must be 13″ by 11 inches.

* Piece C must be nine inches by 11 inches.

Flip and also topstitch items B and C

Fold item B by two lengthwise and after that iron it. Topstitch over the fold a distance of 1/8 inch from the edge. Perform the same with piece C.

Pile the pieces together

Take 1 of the A pieces and place it on your work surface with the face up. Stack piece B on piece A, ensuring that the bottom eleven inches edges are lined up. Place piece C in a similar manner over piece B. Utilise pins to hold the 3 pieces together, ensuring that all the bottom corners are aligned.

Start stitching

Start stitching on the top portion of one side of piece B and make sure that all the layers are held together. There should be a a space of a one-half inch within the base and top part of the other side of piece B.

Attach the hair elastic

Stitch the hair elastic to the side seam to have a loop to be used for the button closure. First measure the midpoint of the right-hand end of the attached piece A. Place the hair elastic at the middle approximately halfway above the one half inch seam. The elastic needs to slightly reach the outside edge of piece A and the remainder will be set above fabric of piece A. Pin your work and tack it down to ensure that you don\’t go above the seam allowance.

Attach the second piece A and felt

Stack the second piece A over the very first piece A that you\’ve already stitched. Make sure the right sides are facing each other. Pin the felt over the 2nd piece. Begin sewing all the layers by using a straight sew from the lower right-hand part. Sew around all 4 parts but leave an opening which measures 3\”.

Add finishing details

Clip the seams along with the edges before you decide to turn your work right side out through the three inches opening. Iron the edge seams as well as the space on the loser portion. Topstitch the exterior sides and be sure that you close the gap. Fold the right on the left part so that a vertical fold is formed and then iron it. Open the holder and sew the vertical fold utilizing a straight stitch. Connect the button on the right section for the closure.

You can now travel without worrying about how to organize your travel documents.

Author Bio: Written by Douglas R. Williams. Check the different purposes of job ticket holders at http://www.everydayplastics.com/JobTicketHolders.php

Category: Society
Keywords: job ticket holders