If you of a mind to make your own fish tank, these helpful instructions will help you with the process. It provides the materials, tools, prep work cialis wiki and step by step directions to completing the project.

Required Materials
Silicon Carbide Sandpaper
Acetone
Glass
Duct tape
Silicon sealant

Instruction
Step one:
Select the size fish tank you will require and figure out the thickness of the glass necessary using a clever aquarium calculator that can be found on the web. This will tell you the aquarium volume, glass thickness, glass area, glass weight and total combined weight of the glass and water.

Step two:
Order the glass from a glass cutter. There will be five pieces of glass required for the tank. (Four sides and the bottom)

Step three:
When you acquire the glass, the edges will be extremely sharp from the glass cutter. Sand the corners of the glass with Silicon Carbide Sandpaper or an emery cloth until they are smooth.

Step four:
Set out the pieces of glass in such a way that they are readily identifiableand correctly label each piece bottom, left, right, back and front with a washable marker. Also mark which sides will be the inside and outside of walls of the tank.

Making Your Fish Tank
Step one:
Tear 20 strips of duct tape that are between 5-6 inches long. Let them hang lightly from the edge of a table or workbench until they are required.

Step two:
Start with the glass that will be the bottom of the tank, lay it on a flat surface with the side marked inside facing up.
Place some acetone on a paper towel or cloth and clean the entire edge of the glass

Step No prescription cialis three:
Cautiously elevate the glass and place eight of the duct tape strips beneath the glass. Position the duct tape so that half if is stuck to the outside of the glass and the other half is dangling free. When set correctly, the sticky side will be facing up. Try to space the tape as equally as possible on each side.

Step four:
Make a line of silicon sealant and along length of the base that will be adjacent to the front pane of glass.

Take the piece of glass that is marked front and position next to the edge you have distinguished as the front of the base

Press the front glass securely to the line of silicon sealant, and move the strips Cialis Professional of duct tape so that the loose pieces cling to the outside of the front pane.

Do not attempt to wipe away any sealant that has leaked out under the edge.

Step five:
Run another line of sealant on the left or right side of the tank as well as on the edge of the front pane where the new piece will be touching.

Step six:
Attach the side panel and ensure it is put securely against both the bottom and front glass.

Hold the glass steady and add two more strips of duct tape to secure the corner and front pieces of glass to each other.

Step seven:
Repeat the previous two steps until all four sides have been fixed to the base and each other with the Silicon sealant and supported by the duct tape.

Step eight:
Run the silicon sealant on all eight interior corners, that is: the four corners that make up the base and the four where each of the walls meet.

Use your fingers to blot the silicone sealant into the edges.

Step nine:
Let the sealant dry for 24 hours before moving to the final step.

Step ten:
Fill your new fish tank with water and observe it for at least 24 hours.

Check to ensure that there are no leaks from any of the joints.

If there are no leaks and the tank does not break or crack from the pressure, Congratulations you have successfully built your own fish tank!

Tips and warnings:
Always use safety gear when handling and sanding glass. Goggles, masks and gloves are necessary.

If you are unsure about the measurements for the thickness of the glass, double check with a pet shop so that the tank will not crack.

Author Bio: Please visit these links for more information on: How to Build a Fish Tank and Build a Fish Tank.

Category: Home/Home Improvement
Keywords: Fish tank, Aquarium, Colorful fish