The first step to installing an automatic gate door is to install a gate motor. However, it all depends with the gate opening. Most people opt to purchase readymade gates. People do the fitting by themselves. You only need your measurements of the desired space and then reinforced with a cross bar. If one is planning to construct a gate from lumber that is raw, they should attempt using a prior designed gate plan. You can always get a how to install an electric fence guideline online. For those who want to purchase the readymade gates this could be the easiest means of obtaining this information.

If you already have a steady wall or fence all you need to do is mount the gate in place. How you decide to install your doors will greatly depend on what you already have. If there are no stable walls, you may have to seek alternative support. You may use a post hole digger to create a stable place to place your gate. You must however set these posts on concrete so as to achieve maximum stability. It is also very important that you do not forget to use a plumb line so as make sure they are straight.

Building a swinging gate only requires the attaching of hinges to one side of the gate and the corresponding post and placing a latch on the other side of the gate and its post. This may require a little more labour than anticipated. There are so many online guidelines on how to install an electric gate. It basically also requires that you attach rollers to the door and a track to the ground or to the fence for support.

Once your door is functioning smoothly under manual operation, then automating it a question of finding the right motor. This must of cause depend on the size of your gate. If it’s a small gate, you will have to get a less sizable motor. The size of the gate has to be proportional to the motor size. Depending on whether your gate slides or swings, manufacturers always have a chart telling you which opener you should buy.

With a sliding gate in place, your entire property will be enclosed. This method is very practical for security purposes. Whenever you enter your premises a remote control will open and when you leave it closes.

Here are some of the tips and warnings that you should adhere to when the question how to install an electric gate crops up. Ensure that you read the instructions that accompany your gate after purchase. Ensure that you have everything you need and you fully comprehend them. You should make the post hole wider at the bottom than at the top as it will be more secure. If the post’s tops are rounded, capped or slanted, they will be more durable as water will not collect. You should also call your local authorities to ensure that you have adhered to the required permits and that you have learnt the local codes if any.

Edward Kendricks writes for CTS (www.cts-networks.co.uk), UK specialists in security gate installation.

Edward Kendricks writes for CTS (http://www.cts-networks.co.uk), UK specialists in electric gate installation.

Author Bio: Edward Kendricks writes for CTS (www.cts-networks.co.uk), UK specialists in security gate installation.

Category: Advice
Keywords: security, home, business, gate, access, crime, technology