No matter how much prevention you make in order to keep the condition of your chimney intact, sooner or later you will be up to the task of fixing an area of your chimney. This can be accomplished though even without acquiring the assistance and aid of a professional worker. Regardless of its demand for physical labor, this can be done by any homeowner with the right equipments, materials, and protective gears. Learning how to repair your chimney adds up to your advantages.

Chimney flue repair can be done in a matter of few minutes or up to an hour depending on the scope of work that needs to be accomplished. In most cases, when a flue requires maintenance services, it is most probably due to cracks and crevices that are accumulated in the long run due to the consistent battering of heat and thermal shock. No matter how durable the materials used on chimneys, they would still require fixing and replacement jobs.

Below is a guide on how you can properly fix your chimney flue with simple methods.

-Clean and Clear – just like any other repair guide, cleaning and clearing debris off your chimney flue is very important to the success of your project. It would be much easier to work on something that is clear of anything that will distract the job. In addition, working on an area that is clean would make the problem quite easier to spot. This will also help you catch a hint on how much scope of work should be done for the project.

-Remove Damaged Bricks and Loose Mortar – immediately after you are done cleaning, it is very important to remove any damaged brick as well as loose mortar before you proceed with the repair works. This is in order to make sure that there will be no additional problems in the long run. Preventing future problem is vital for the longevity as well as the cost effectiveness of your project. Mark areas that require immediate attention to avoid overlooking such problems.

-Repair or Replace – patch up areas that have small cracks and crevices as much as possible to avoid enlarging the holes. It is also important to seal them off with a sealing product before you leave the working area to ensure proper repair works. However, in case the bricks are not fit for repair, the best thing to do is to carefully remove them and replace them with a new one. It is also a good time to apply new mortar on the joints of the bricks to strengthen the attachment or bond with each other.

-Seal – regardless of repair or replacement service, it is very important to seal off the brick chimney on the areas where work has been done. This is in order to make sure that water as well as moisture does not sip in on the small openings or pores of the material.

-Inspect Work – similar to the other repair services, you would need to inspect your work in order to ensure that the right process was done.

I write for TIR Massage Stone about choosing the right hot stones for a hot stone massage kit

I write about hot stones and hot stone massage kit information for http://www.TirMassageStone.com

Author Bio: I write for TIR Massage Stone about choosing the right hot stones for a hot stone massage kit

Category: Advice
Keywords: hot stone massage kit, hot stones, Chimney Flue Repair Guide