Ford stereos are generally compatible with all its brand vehicles since the company products fits best with the same company vehicle except for very few which depends on vehicle model where the connecting segments changes drastically but still it can be still used by attaching a proper converter, if you’re looking to replace your old ford stereo with a new one this instruction on how to install a ford stereo will provide you with all the required information that is aids you on to remove the stereo from your old car and steps that helps you to fix the stereo in your new vehicle .

In order to remove and fix the stereo we need few sophisticated tools like star head screw driver for tightening the front panel, DIN u-shaped tools which are required to remove the stereo from the dash board, connecting wires, converters( if the connecting segments differ) and tapes.

Ford stereos differ in their installation or removal by two ways they are either of dash removal type where we need to remove the dash panel and pull out the stereo the other type is spring clip which is relatively easier to remove than dash panel type, by simply releasing the clips holding the stereo.

First we’ll see the ways to remove the stereo from dash removal type, here the dash panel which is covering the stereo is removed by releasing the screws on all the four corners of the stereo using the star head screw driver, then pull out the panel covering the stereo, the stereo are resting over a click type plastic clips which can released by pressing them hardly using a flat screw driver, remove the stereo gently.

Disconnect the wires connecting the stereo and remove its entire contacts so that it is totally isolated from the car, now insert the new stereo into the dash board and connect the wires, check the wire connections of the new stereo which you have installed to the dash board make sure the connections are complete by turning on the stereos and checking its sound quality. After checking the connections tighten the screw by using star head screw driver and put back the dash panel to complete the installation.

For spring clip type we’ll be using the DIN tool here where the clips are released using the DIN tool by press them hardly over it, after hearing the release sound the DIN tool is turned outward to pull out the stereo.

After pulling out the stereo keep it aside and disconnect the wires, make sure the stereo is completely isolated from the car and insert the new stereo into the dash board and push it hardly until you hear a click noise, the noise confirms that the stereo is in place after that check the wire connection by turning on the stereo if there is no disturbance in its sound quality the installation is complete else check the wiring again.

This instruction on how to install a ford stereo helps the reader to remove and install the ford stereo without the need for supervision.

Author Bio: If you are interested in more information, the Author shares the Ford site. This article was written by the business marketer from powernetshop.at with his Autoradio site, he shares you the tips you learned in this article. The company has a large product collection on Autoradioblende accessories in the Internet

Category: Automotive
Keywords: Ford, fascia plate, radio dash kit, fascia panel, radio installation kit, powernetshop.at