Staining your wooden deck would be the most appropriate way of preserving its condition against all type of weather that would definitely batter it throughout the year. A deck without this solution would easily succumb to the gradual yet devastating effects of rain, heat, and cold. Applying the stain on the wooden material is quite easy and can be done in a matter of few minutes or depending on the area that requires painting job. This can be done by any homeowner as it does not require any set of skills and experience at all.

However, coating the deck should not be done at any given day and times as there are things that should be considered in order to ensure the efficacy and success of your project. Make sure that all things to be considered are taken note of and that the common mistakes should be avoided to ensure proper rendering of the stain all over the area.

-Clean Deck – it is a pre-requisite job to make sure that the deck is clean of anything that can cause an uneven surface in case you have painted or stained it with your preferred solution. Use a quality broom to get the job done as this cleaning tool can get to the joints of the board which can be quite hard to reach and it is the part where dirt and debris usually settles in.

-Sand – in order to smoothen up and even the surface of the deck, you should use sandpaper to sand the wooden material. This is commonly done prior to painting and staining works as it helps prepare the wood for proper absorption and sealing purposes. In most cases, a coarser type of sandpaper is used for the starting process of the project. As you near the finishing part of the job, you can shift to a finer type of sandpaper for the last course. Make sure that the surface is smooth and is ready for the painting job before you stop with the work.

-Perfect Time – do not apply the stain during the heat or hottest part of the day as your staining solution would not properly penetrate on the wooden material. Aside from the scorching heat of the sun on your skin, this would leave a negative effect on your project which will not be good for the visual appeal and protection of deck. Working early in the morning or late in the afternoon with the staining job would be the best time of the day for this to be accomplished.

-Brush – a good brush with firm bristle should be utilized in order to properly distribute the solution on the entire surface of the deck. The best method is by starting at the top part of the deck going down and out to the exit of the structure in order to avoid touching and destroying the finished part of the deck.

-Let Dry – after you are through, settle for a while in order to let the solution dry before you inspect your work. Through this you will know whether improvement is required or your project was a success.

I write for TIR Massage Stone about hot stone massage supplies and Basalt hot stones used for massage therapy.

I write for http://www.tirmassagestone.com about hot stone massage

Author Bio: I write for TIR Massage Stone about hot stone massage supplies and Basalt hot stones used for massage therapy.

Category: Advice
Keywords: hot stone massage , hot stones, Apply Stain On Deck